227,12 → 227,12 |
} |
if (!pdev) |
continue; |
printk(KERN_INFO "ne.c: PCI BIOS reports %s at i/o %#x, irq %d.\n", |
printk(KERN_INFO "ne.c: PCI BIOS reports %s at i/o %x, irq %d.\n", |
pci_clone_list[i].name, |
pci_ioaddr, pci_irq_line); |
printk("*\n* Use of the PCI-NE2000 driver with this card is recommended!\n*\n"); |
if (ne_probe1(dev, pci_ioaddr) != 0) { /* Shouldn't happen. */ |
printk(KERN_ERR "ne.c: Probe of PCI card at %#x failed.\n", pci_ioaddr); |
printk(KERN_ERR "ne.c: Probe of PCI card at %x failed.\n", pci_ioaddr); |
pci_irq_line = 0; |
return -ENXIO; |
} |
285,7 → 285,7 |
if (ei_debug && version_printed++ == 0) |
printk(version); |
|
printk(KERN_INFO "NE*000 ethercard probe at %#3x:", ioaddr); |
printk(KERN_INFO "NE*000 ethercard probe at %3x:", ioaddr); |
|
/* A user with a poor card that fails to ack the reset, or that |
does not have a valid 0x57,0x57 signature can still use this |
473,7 → 473,7 |
dev->dev_addr[i] = SA_prom[i]; |
} |
|
printk("\n%s: %s found at %#x, using IRQ %d.\n", |
printk("\n%s: %s found at %x, using IRQ %d.\n", |
dev->name, name, ioaddr, dev->irq); |
|
ei_status.name = name; |
638,7 → 638,7 |
} while (--tries > 0); |
if (tries <= 0) |
printk(KERN_WARNING "%s: RX transfer address mismatch," |
"%#4.4x (expected) vs. %#4.4x (actual).\n", |
"%4.4x (expected) vs. %4.4x (actual).\n", |
dev->name, ring_offset + xfer_count, addr); |
} |
#endif |